Readers ask: How To Install Sheep Netting?

How do you install a mesh fence?

The best way to attach mesh fencing to wood posts and rails is with galvanized U-staples. I suggest using staples no smaller than 3/4 inch for this purpose. Roll the fencing from the first post to the second, and then fasten the edge to the first post.

How far apart should fence posts be for sheep?

For standard mild steel wire, posts should be no more than 11ft apart, but a good contractor using high-tensile wire could happily up this to 20ft. However, 13ft is the most common spacing used.

Does electric fence work for sheep?

Permanent electric fencing with five to eight properly spaced strands is excellent for holding sheep. Experience has shown that a seven or eight wire fence that is approximately 48 inches high is ideal for sheep and cattle. This fence will not only keep sheep in, but will also work well for keeping predators out.

How long is a roll of sheep wire?

Fencemor Sheep Wire Fence – 45m is a light sheep wire fence in a 45 metre (50 yard) roll. It comes with five, six or 10 line wires, all with a 15cm box. Light sheep wire is used primarily for temporary fencing or for patching up a boundary or internal fence.

You might be interested:  FAQ: Describe How Nuclear Transplantation Was Used To Produce Dolly The First Cloned Sheep?

How deep should a strainer post be?

The strainer post should be no less than 150 to 200mm in diameter and buried 1 metre into the ground. The stay is of similar diameter to fence posts (100 to 125mm), its length is determined by the position on the strainer.

How do you pull a sheep wire fence?

Using loops of steel wire, attach two wire pullers to the strainer post at the height that you want the top and bottom strands of your sheep wire. Apply a pull to the bottom strand of the sheep wire first, until the wire comes tight to the fence line. Then put a pull on the top strand.

How do you tension a wire net?

One way of getting netting as tight as a drum once it is up is to use a pair of pliers and quarter to half twist the holes in the loose areas until the area is tightened to your liking. You will be surprised how quickly you can tightn a span of wire.

Leave a Reply

Your email address will not be published. Required fields are marked *